Welcome to Hangzhou Kejie!

Micro–Heat Compressed Air Dryer

Short Description:

The micro-heat regenerative adsorption air dryer  (micro-heat dryer) is R & D products by used to absorb two kinds of advantages, such as micro-heat regeneration and heatless regeneration.

Product Detail

Product Tags

Product Details

The ability to adsorb water by a desiccant, and the compressed air is dried by the principle of variable temperature and pressure swing adsorption. The regenerated gas can be used to regenerate desiccant after raising the temperature, which not only improves the regeneration effect, but also reduces the consumption of regenerated gas.

The micro-heat regenerative adsorption Air Dryer (micro-heat Dryer) is a kind of R & D product which absorbs the advantages of micro-heat regenerative and non-heat regenerative, and can reduce the consumption of regenerative gas. Using the desiccant water adsorption capacity, the use of temperature and Pressure swing adsorption principle to dry Compressed air. The regenerated gas can be used as the regenerative desiccant after the temperature is raised, which not only improves the regenerative effect, but also reduces the consumption of the regenerative gas. The micro heat regenerative dryer uses the low dew point Compressed air provided by this machine to desorb and regenerate the adsorbent. It has no definite requirement for the temperature of gas generation, but it is generally far below the minimum desorption temperature required for the “Variable temperature adsorption”of adsorbents, so in essence, “Micro-heat”regeneration is still within the scope of PSA, the purpose of heating regeneration gas is to reduce the consumption of regeneration gas. Secondly, as the regeneration gas with low dew point has provided the necessary environmental conditions for the desorption of the adsorbent, the limited increase of the temperature of the regeneration gas can speed up the desorption rate is not important for the dryer. However, the exhaust temperature of the regenerated exhaust gas is directly related to the consumption of the regenerated gas. The higher the temperature of the regenerated exhaust gas, the more water vapor it can absorb.

Technical Indexs

1  capacity:  10-20000Nm3/min
2 Nitrogen purity: 299. 9995%.
Nitrogen Pressure. 0.1-0.7MPa(adjustable)
3 Oxygen content ≤5ppm
4 Dust content: ≤0.01um
5 Dew point: ≤-60°C.

  • Previous:
  • Next:

  • Write your message here and send it to us